Single Button Cheese Dispenser Model No. 5345 Table of Contents SAFETY PRECAUTIONS ........................... 3 Inspection of Shipment ............................5 INSTALLATION INSTRUCTIONS ........................5 Manual ..................................5 Model Description ..............................5 Items Included with this Unit ........................... 5 Setup ................................... 5 Electrical Requirements .............................
Read and understand operator’s manual and all other safety instructions before using this equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862 022_060215 gmpopcorn.com...
Page 4
Note: Improvements are always being made to Gold Medal’s equipment. This information 007_010914 may not be the latest available for your purposes. It is critical that you call Gold Medal’s Technical Service Department at 1-800-543-0862 for any questions about your machine operations, replacement parts, or any service questions.
To order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862. Model Description 5345: Single Button Cheese Dispenser with a manual dispense button only. Items Included with this Unit • Manual and Warranty Registration Card •...
We recommend this equipment be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold Medal Products Co.’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance.
• Set of Decals - for door, right and left panels, rear panel, and bottom panel (if applicable). Items Needed for Installation: • Gold Medal Watchdog Glass Cleaner (Item No. 2588) or a non-ammonia type glass cleaner. • Plastic squeegee, medium size applicator (type used for Bondo filler).
Page 8
Single Button Cheese Dispenser Model No. 5345 Step 3: Peel paper backing down from top few inches of decal (Figure B). Do not remove the Align Decal Align decal at the top, then place on unit. at the top. entire paper backing all at once.
Single Button Cheese Dispenser Model No. 5345 OPERATING INSTRUCTIONS Controls and Their Functions POWER SWITCH – Turns the unit ON/OFF. THERMOMETER – Displays the air temperature inside the cabinet. The unit is factory set to a default temperature level for warming the product. To change the temperature setting, have qualified service personnel reference Adjusting the Thermostat, in the Maintenance section of this manual.
Single Button Cheese Dispenser Model No. 5345 Product Installation and Removal The dispenser is equipped with a Bag Support Tray to hold the bag of cheese in use, and an upper Cheese Bag Tray to hold a bag of cheese for pre-warming.
Page 11
Single Button Cheese Dispenser Model No. 5345 Step 4: Remove the Upper Cheese Bag Tray. Place the product in support tray with spout and tube directed toward the front, and downward through the tray opening. in position (for product Basket Liner must be bag with a small cap).
Single Button Cheese Dispenser Model No. 5345 Care and Cleaning DANGER Machine must be properly grounded to prevent electrical shock to personnel. DO NOT immerse in water. DO NOT clean appliance with a water jet. Always unplug the equipment before cleaning or servicing.
Single Button Cheese Dispenser Model No. 5345 Troubleshooting A. Power to Unit A. Make sure the unit is securely plugged into the Issue Possible Cause Solution wall outlet. Units with an IEC power cord, Unit Not Working make sure cord is securely plugged into unit.
Single Button Cheese Dispenser Model No. 5345 MAINTENANCE INSTRUCTIONS DANGER Machine must be properly grounded to prevent electrical shock to personnel. Failure to do so could result in serious injury, or death. DO NOT immerse any part of this equipment in water.
Single Button Cheese Dispenser Model No. 5345 Adjusting the Thermostat This dispenser is preset at the factory with a default temperature setting to heat the unit interior. The thermostat setting must be changed by qualified service personnel only. Follow the steps below to adjust the interior air temperature of the unit:...
4. Please include your model number, serial number, and date of manufacture (located on the machine nameplate/data plate) with your order. 5. Address all parts orders to Parts Department, Gold Medal Products Co., 10700 Medallion Drive, Cincinnati, Ohio 45241-4807 or place orders by phone or online:...
Single Button Cheese Dispenser Model No. 5345 Cabinet Front and Interior View 5345 Basket Liner Inside view of Bag Support Tray 9, 10 General images shown for parts reference only. Pump Block – Detail View Part Number Item Part Description...
Pump Assembly. 5, 6 *CAUTION: If supply cord is damaged, it must be replaced General images shown by Gold Medal Products Co., its service agent, or for parts reference only. similarly qualified persons in order to avoid a hazard. Part Number...
Need help?
Do you have a question about the 5345 and is the answer not in the manual?
Questions and answers