Toshiba e-Studio2000AC Hardware Troubleshooting Manual page 40

1.TROUBLESHOOTING FOR THE HARDWARE
7 When the finisher is installed, close the Bridge Kit cover.
8 Remove the paper from the lower part of the fuser unit.
 Pull out the misfed paper in a just-under direction.
 If it is difficult to remove the misfed paper, press the envelope lever down and then remove it. Be sure to return
the envelope lever to its original position after removing the misfed paper.
9 Close the transport guide holding the green knob.
10 Close the automatic duplexing unit cover.
40 Clearing a Paper Misfeed