Toshiba e-Studio2000AC Hardware Troubleshooting Manual page 21

1.TROUBLESHOOTING FOR THE HARDWARE
(e-STUDIO5005AC Series / e-STUDIO5008LP Series) Do not touch the
transfer belt.
When you remove the paper misfed in the right side of the equipment, be
sure not to touch the transfer belt. This could stain copy images.
(e-STUDIO5008A Series) Do not touch the photoconductive drum.
When you remove paper which has been misfed in the right side of the
equipment, be sure not to touch the photoconductive drum. This could
stain the copy images.
 If paper misfeeds occur frequently
The following are the common causes of paper misfeeds. If the problem persists, check for the following situations.
 An unsuitable original is placed on the ADF.
 Unavailable paper with the equipment is used.
 Paper sizes are not consistent between the size in a drawer or the bypass tray and the size registered in the
equipment.
 All the misfed paper has not been removed.
 There is too much of a gap between the paper and the side or end guide in the drawer.
 The amount of paper placed in a drawer exceeds the limit indicated on the side guide of the drawer.
Clearing a Paper Misfeed 21