Mira Platinum Dual Installation Manual page 39

Run cold water through (approximately
2 minutes) and check entire installation
for water leaks. Press "
off. Fit the second hose washer and
showerhead.
1
Press " " to turn shower on. Test
operation of shower by increasing/
decreasing both temperature and flow
controls. (See User Guide for full details.)
Test operation of showerhead spray
modes. (See Showerhead User Guide for
full details.)
Repeat process for outlet 2 by pressing
2
" " button.
Refer to User Guide for further instructions on how to use the shower.
The Wireless Controller factory default settings are as follows:
Maximum Showering Temperature = 45°C
Eco Mode
Warm-Up Mode
Clock
Clock Display
Shower Duration
Bath Fill Mode
Note! If the display reads 4:00 when the batteries are connected the
wireless controller will require registering, refer to the initial registration
process in section
Run the shower and adjust the maximum shower temperature to suit user
requirement.
Eco, warm-up and clock display can also be altered to suit, refer to wireless
controller guide.
1
" to turn shower
"Digital Mixer Valve: Position and Signal Test".
39
= Off
= Off
= 10:00 (when batteries connected)
= On
= Off
= Off
1199702-W2-G