Overview; Console Port Signals And Pinouts - Cisco AIR-AP1251AG-A-k9 Hardware Installation Manual

Overview

Overview
The access point requires a special serial cable that connects the access point serial console port (RJ-45
connector) to your PC's COM port (DB-9 connector). This cable can be purchased from Cisco (part
number AIR-CONCAB1200) or can be built using the pinouts in this appendix.

Console Port Signals and Pinouts

Use the console RJ-45 to DB-9 serial cable to connect the access point's console port to the COM port
of your PC running a terminal emulation program.
Both the Ethernet and console ports use RJ-45 connectors. Be careful to avoid accidently connecting the
Note
serial cable to the Ethernet port connector.
After completing your configuration changes, you must remove the serial console cable from the access
Note
point.
Table E-1
Table E-1
Console Port
RJ-45
Pins
1
2
3
4
5
6
7
8
1. NC indicates not connected.
2. TXD indicates transmit data.
3. RXD indicates receive data.
4. GND indicates ground.
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
E-2
C I S C O C O N F I D E N T I A L - D r a f t A 1
lists the signals and pinouts for the console RJ-45 to DB-9 serial cable.
Signals and Pinouts for a Console RJ-45 to DB-9 Serial Cable
PC COM Port
DB-9
Signals Pins Signals
1
NC – –
1
NC – –
2
TXD 2 RXD
4
GND 5 GND
3
GND 5 GND
5
RXD 3 TXD
1
NC – –
1
NC – –
3
4
4
2
Appendix E Console Cable Pinouts
OL-8247-02