Installing The Access Point To The Mounting Plate; Mounting Plate Not Attached To A Surface - Cisco AIR-AP1251AG-A-k9 Hardware Installation Manual

Chapter 2 Installing the Access Point

Installing the Access Point to the Mounting Plate

There are two methods used to install the access point to the mounting plate:
•
•
When the mounting plate is not attached to a wall or ceiling surface, the access point can be turned over
to simplify the installation process.
The mounting plate latch must be on the access point bottom plate to enable the mounting plate to be
installed (see the
The access point is shipped with the mounting plate latch and the mounting plate installed.
Note

Mounting Plate Not Attached to a Surface

When the mounting plate is not attached to a wall or ceiling surface, follow these steps to attach the
mounting plate on the access point:
Step 1 Position your access point with the bottom plate facing you.
Step 2 Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
inserted andboth module latches are in the locked position (see
OL-8247-02
C I S C O C O N F I D E N T I A L - D r a f t A 1
Attached to a surface
Not attached to a surface
"Installing the Mounting Plate Latch" section on page
Installing the Access Point to the Mounting Plate
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
2-18).
Figure 2-16).
2-19