Cisco AIR-AP1251AG-A-k9 Hardware Installation Manual page 74

Low Power Condition on Autonomous Access Points
Configuring the Access Point System Power Settings Using a Browser
You can also use your browser to set the access point system power settings.
Note The access point web-browser interface is fully compatible with Microsoft Internet Explorer version 6.0
on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, Windows 2000, and
Solaris platforms.
Note When using the access point browser interface, you should disable your browser pop-up blocker.
Figure 3-3
series power injector detected).
Figure 3-3
Table 3-5
commands for several power options.
Table 3-5 System Power Settings and Cisco Switch Commands for Access Points with a Single Radio Module ??
Power Source
AC power module
Cisco switch that supports
Intelligent Power Management
Cisco switch that does not
support Intelligent Power
1
Management
2
Power injector used with a
Cisco switch that supports
Intelligent Power Management
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
3-14
C I S C O C O N F I D E N T I A L - D r a f t A 1
shows the system power setting options and indicates the access point power status (1250
System Power Settings
and Table 3-6 lists the access point system power settings and the Cisco switch power
Access Point System Power Settings
Configuration changes are not required
Power Settings:
1
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Pre-standard Compatibility (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Power Negotiation (selected)
1
Power Injector:
Installed on Port with MAC Address (unchecked)
Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
- TBD
Cisco Switch
Power Command
power inline never
power inline auto
power inline auto
power inline never
OL-8247-02