Table of Contents
Advertisement
Replacing the power button with
fingerprint reader
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Place the power button with fingerprint reader into the slot on the palm-rest
assembly. Then adhere the power button with fingerprint reader cable connector
to the keyboard bracket.
2
Replace the two screws (M2x2.5) that secure the power button with fingerprint
reader to the palm-rest assembly.
3
Open the power button with fingerprint reader cable connector latch and
connect the power button with fingerprint reader cable to the power button with
fingerprint reader.
4
Adhere the power button with fingerprint reader cable to the fan.
5
Open the system board connector latch and connect the power button with
fingerprint reader cable to the system board.
Post-requisites
1
Replace the
I/O
2
Replace the
wireless
3
Replace the
base
computer. After working inside your computer, follow
After working inside your
board.
card.
cover.
computer. For more safety best
www.dell.com/
Before
67
Advertisement
Table of Contents
