Table of Contents
Advertisement
Replacing the I/O board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Place the I/O board on the palm-rest assembly and keyboard bracket.
2
Align the screw holes on the I/O board with the screw hole on the palm-rest
assembly and the screw hole on the keyboard bracket.
3
Replace the two screws (M2x2) that secure the I/O board to the keyboard
bracket.
4
Connect the coin-cell battery cable to the I/O board.
5
Slide the I/O-board cable into the connector on the I/O board and close the
latch to secure the cable.
6
Adhere the adhesive tape covering the I/O-board cable connector on the I/O
board.
Post-requisites
1
Replace the
wireless
2
Replace the
base
computer. After working inside your computer, follow
After working inside your
card.
cover.
computer. For more safety best
www.dell.com/
Before
47
Advertisement
Table of Contents
