Entering The Geofence Area - Motorola ASTRO APX O5 User Manual

the new selected Dynamic Regrouped talkgroup with
green intelligent light for your attention.
On top of that, additional features are Voice
Announcement of the new channel, and also direct
content display of a text message to indicate that you
are currently at Geofence area. Check with your
nearest qualified technician on the requirements for
these enhancements to work in Geofence.
Any new text messages received at Geofence shall
have its content displayed immediately on the radio
display.
Note:
If the radio is set up in DVRS, only mobile
radio is supported for this feature.

Entering the Geofence Area

The Voice Announcement and TMS display in this
feature are optional. They must be configured to
enable you to hear and see these indicators.
When the radio enters a Geofence area, the radio
immediately sends a message ACK back to the
system.
The radio searches the current zone for the channel
with same talkgroup assigned as the Dynamic
112
English
Talkgroup and also with same system ID of current
trunk system. Once matched, the radio display shows
the first matched and connected channel alias.
If there is no channel with matched Talkgroup ID and
trunk system ID, the radio display shows the channel
alias of <DYNAMIC talkgroup>.
Once the radio is connected, you hear a dynamic
regroup tone, the radio display shows <DYNAMIC
channel> with temporary green color intelligent
backlight and you hear a Voice Announcement.
Note:
When the radio loss the GPS signal the GPS
icon blinks and the radio sounds two high-
pitched tones repetitively to indicate GPS fails
to operate. The radio display shows red
intelligent light.
Note:
If the first matched channel is not configured
with Voice Announcement, no Voice
Announcement is played.
The system sends a message to your radio. The
radio display shows a direct text message content
without any user operation. This message indicates
you are currently present in a Geofence area. This