Clearing Micro-Burst Detection - Cisco Nexus 9000 Series Configuration Manual

Micro-Burst Monitoring
Command or Action
Step 6 exit
Example:
switch(config-pmap-que)# exit
switch(config)#
Step 7
interface ethernet slot/port
Example:
switch(config)# interface ethernet 1/1
switch(config-if)#
Step 8
service-policy type queuing output policy-map-name
Example:
switch(config-if)# service-policy type queuing
output custom-out-8q-uburst

Clearing Micro-Burst Detection

You can clear micro-burst detection for all interfaces or a selected interface.
Note Even after removing the queuing policy from an interface, previous micro-burst statistics remain. Use the
clear queuing burst-detect command to clear the remaining records.
Procedure
Command or Action
Step 1
clear queuing burst-detect [slot] [ interface port [queue
queue-id]]
Example:
Example
• Example for an interface:
• Example for a queue:
clear queuing burst-detect interface Eth1/2
clear queuing burst-detect interface Eth1/2 queue 7
Cisco Nexus 9000 Series NX-OS Quality of Service Configuration Guide, Release 7.x
Purpose
Exits policy-map queue mode.
Configures the interface.
Adds the policy map to the input or output packets of the
system.
Purpose
Clears micro-burst information from all interfaces or the
specified interface.
Clearing Micro-Burst Detection
177