Think Safety First - Toro 74253 Operator's Manual

Important: Lower the roll bar only when
absolutely necessary.
1. Remove the hairpin cotter pins and remove the two
pins (Figure 7).
2. Lower the the roll bar to the down position. There
are two down positions. See Figure 6 for the
positions.
3. Install the two pins and secure them with the
hairpin cotter pins (Figure 7).
1. Full down position
Important: Ensure that the rear part of the
seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 7).
5. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 7).
Important: Always use the seat belt with the
roll bar in the raised position.
Figure 6
2. Down position with bagger
installed
1
3
4
1. Roll bar
2. Raised position

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
16
2
G004955
Figure 7
3. Pin
4. Hairpin cotter pin