Drive System Maintenance; Adjusting The Tracking - Toro 74253 Operator's Manual

Figure 45
1. Fan-30 amp
2. Engine-10amp
3. Optional accessory
4. Ignition-30amp
5. Left side of machine
Drive System
Maintenance

Adjusting the Tracking

The machine has a knob for adjusting the tracking
located under the seat.
Important: Adjust the handle neutral and hydraulic
pump neutral before adjusting the tracking. Refer
to Adjusting the Handle Neutral in Controls System
Maintenance , page 45 and Adjusting the Hydraulic
Pump Neutral in Hydraulic System Maintenance ,
page 46.
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side. If it does,
stop the machine and set the parking brake.
3. Unlatch the seat and tilt the seat forward to access
the tracking knob.
Note: Determine the left and right sides of the
machine from the normal operating position.
4. To make the machine go right, turn the knob towards
the rightside of the machine. Refer to Figure 46.
5. To make the machine go left, turn the knob towards
the leftside of the machine. Refer to Figure 46.
6. Repeat adjustment until the tracking is correct.
37