Toro 74253 Operator's Manual page 53

Figure 75
1. Cutting Edge
2. Curved Area
Checking for Bent Blades
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Rotate the blades until the ends face forward and
backward (Figure 76). Measure from a level surface
to the cutting edge, position A, of the blades
(Figure 76). Note this dimension.
3. Wear/slot forming
4. Crack forming
1. Measure here from blade
to hard surface
4. Rotate the opposite ends of the blades forward.
5. Measure from a level surface to the cutting edge of
the blades at the same position as in step 3 above.
The difference between the dimensions obtained in
steps 3 and 4 must not exceed 1/8 inch (3 mm). If
this dimension exceeds 1/8 inch (3 mm), the blade
is bent and must be replaced; refer to Removing the
Blades and Installing the Blades.
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
• Always replace bent or damaged blade with
a new blade.
• Never file or create sharp notches in the
edges or surfaces of blade.
Removing the Blades
Blades must be replaced if a solid object is hit, if the
blade is out of balance or is bent. To ensure optimum
performance and continued safety conformance of
the machine, use genuine TORO replacement blades.
Replacement blades made by other manufacturers may
result in non-conformance with safety standards.
53
Figure 76
2. Position A