Controls - Toro 74253 Operator's Manual

1. Lift assist lever
2. Height-of-cut lever
3. Motion control levers
4. Roll bar
5. Seat belt

Controls

Become familiar with all the controls before you start the
engine and operate the machine (Figure 3 and Figure 4).
1. Fuel tank cap
2. Malfunction indicator light
(MIL)
3. Engine Temperature light
4. Throttle control
Hour Meter
The hour meter records the number of hours the engine
has operated. It operates when the engine is running.
Figure 3
6. Controls
7. Fuel cap (both sides)
8. Parking brake lever
9. Caster wheel
10. Mower deck
Figure 4
5. PTO Switch
6. Hour meter
7. Ignition switch
Use these times for scheduling regular maintenance
(Figure 4).
Temperature Light
The temperature light comes on when the engine is over
heating (Figure 4).
Audible Alarm
This machine has an audible alarm that alerts the user
to turn off the engine or engine damage can occur from
over heating. Refer to Servicing the Cooling System in
Cooling System Maintenance , page 40.
Fuel Selector Valve
The fuel selector valve is located under the left side of
the seat (Figure 5).
Close the fuel selector valve when transporting or
storing mower.
Move the selector valve to the lefthand (LH) or
righthand (RH) position for operation.
Malfunction Indicator Light
The electronic control unit (ECU) continuously
monitors the operation of the fuel system.
If the malfunction indicator light (MIL) illuminates,
during operation, the electronic control unit (ECU) has
detected a problem or fault in the direct fuel injection
(DFI) system.
Once the MIL illuminates, initial trouble shooting
checks should be made. Refer to the MIL section under
Toubleshooting.
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service Dealer
is necessary.
13