1.800.561.8187
6.3.1.1 Data Displayed in Standard Mode
The last measurement is displayed. The MR
symbol and the sequence number of the
record being recalled are also displayed.
Figure 6-11 illustrates an impedance plus a
current measurement (Ω+A setting).
The stored values are displayed as they were
when recorded: same display range, alarm
states, NOISE signal, battery condition, etc.
However, the audible alarms are not
reproduced; only the AL symbol and the alarm
threshold blink.
Figure 6-12 illustrates a current measurement
(A setting).
Press ► to display the measurement storage
date/time screen.
To exit from the MR mode, set the rotary
switch to the desired mode.
32
www.
Figure 6-11
Figure 6-12
Figure 6-13
Clamp-on Ground Resistance Tester Model 6416
information@itm.com
.com