Table of Contents
Advertisement
Figure 41
Drive axel at engine, five, one each side and slip joint
1. Grease point
Figure 42
Drive axel at transmission
1. Grease point
Figure 43
Steering pivot above steering rods
1. Grease point
Greasing the Boom Hinges
Service Interval: Every 100 hours
Important: If the boom hinge is washed with
water, all water and debris must be cleared from the
hinge assembly and fresh grease must be applied.
Grease Type: No. 2 general-purpose lithium base
grease.
1. Wipe the grease fittings clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing at each
fitting Figure 44.
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each boom pivot.
Greasing the Actuator Rod
Bearings
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Grease Type: No. 2 general-purpose lithium base
grease.
1. Extend the booms to the spray position.
2. Remove the cotter pin from the pivot pin (Figure 45).
42
Figure 44
Right boom
Advertisement
Table of Contents
