Using The Meat Probe - Fisher & Paykel OB30DDEPX1 User Manual

Using your oven
16
US
CA

Using the meat probe

Use your meat probe to accurately judge when your meat is perfectly cooked. You can use the
probe on TRUE AERO, AERO BAKE, ROAST, AERO BROIL and BAKE functions.
Select the oven function and temperature. Preheat the oven if
1
appropriate. Remember ROAST and AERO BROIL do not require
preheating.
Insert the metal probe horizontally into the center of the
2
thickest part of the fully defrosted meat. The thicker the
meat, the longer it will take to cook, so it is important that
the probe is measuring the temperature of the meat at its
thickest point. Make sure the probe does not touch bone (pull
probe away from bone ½ "(1.5 cm)), fat or gristle, as these will
heat up more quickly than the lean meat.
Place the meat on the broil/roast system.
3
When the oven has preheated (if required) to the set
4
temperature, place the broil/roast system in the oven and
insert the plug end of the meat probe into the probe socket,
using an oven mitt if the oven is hot. The probe socket is on
the left hand side of the oven, just under shelf position 7.
Make sure the probe is pushed completely into the socket,
then close the oven door.
Select the upper or lower oven for double models using the
5
cavity selector button.
Press the
PROBE
6
will light up in the display. If you want to select a different internal food temperature from the
preset temperature, rotate the
temperature guidelines, see the 'Cooking guidelines' section.
During cooking, the display will show the actual internal temperature of the meat. To look at the
7
set internal temperature, press
The oven will beep and automatically turn off when the meat reaches the set internal
8
temperature. The temperature and function displays will remain on and the oven light will go
out.
Return the oven to manual operation by pressing the
9
temperature knobs to OFF.
To cancel the probe setting before the set temperature has been reached, press the
PUSH TO
and then the
button on the control panel. The preset temperature of 150°F (65°C) and PROBE
PUSH TO
CLEAR
.
PROBE
button.
CLEAR
c
button while the
PROBE
PUSH TO
CLEAR
d a
Metal probe
a c
Plug
b d
symbol is flashing. For
button. Turn the function and
PROBE
b
c
Handle
Cable
button