Setting Up The Monitor; Attaching The Stand - Dell UltraSharp UP2516D User Manual

Setting Up the Monitor

Attaching the Stand

NOTE: The stand riser and stand base are detached when the monitor is shipped
from the factory.
NOTE: The procedure below is applicable for the default stand. If you purchased
any other stand, see the documentation shipped with the stand to set it up.
CAUTION: Place monitor of a flat, clean, and soft surface to avoid scratching the
display panel.
To attach the monitor stand:
• Remove the monitor protective cover and place the moitor with its front facing
downward on it.
• Insert the two tabs on the upper part of the stand to the groove on the back of
the monitor.
• Press the stand down till it snaps into its place.
Setting Up the Monitor | 23