Sanyo SAP–K91AA Technical & Service Manual page 51

TIMER ON button
TIMER OFF button
TIMER SET button
MODE selector button
(COOL)
FLAP button
NOTE
FAN SPEED selector
1 HR. TIMER button
(1-HOUR OFF TIMER)
ACL button
(ALL CLEAR)
ADDRESS switch
A/C SENSOR button
NOTE
NOTE
OI-005-09EG
Remote Control Unit (continued)
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
This button is used to set the time at which you wish the air
conditioner to go on or off.
Use this button to select DRY or COOL mode.
(DRY) : The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
T o switch to the sweep function (
hold down the FLAP button.
: The air conditioner automatically decides the fan speeds.
button : High fan speed.
: Medium fan speed.
: Low fan speed.
: When you press this button, regardless of whether the unit is
1
HR.
operating or stopping, the unit operates for one hour and
then shuts down.
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
• The address switch changes to prevent mixing of signals from remote
control units when two Sanyo air conditioners are installed next to
each other. Normally, the address switch is set to A. When switching
the address, the remote control must be changed, and the jumper
cables on the indoor unit board must be cut. For more information,
please contact the dealer where you made the purchase.
• Normally, the tabs on the remote control unit should not bent.
When you press this button (use a small-tipped object such as a ballpoint
pen), the
is detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space
heater or in direct sunlight, press the A/C SENSOR button to switch to
the sensor on the indoor unit.
The remote control unit sends the temperature signal to the air
conditioner regularly at three minute intervals. If the signal from the
remote control unit stops for more than ten minutes due to the loss of
the remote control unit or other trouble, the air conditioner will switch
to the temperature sensor which is built into the indoor unit and control
the room temperature. In these cases, the temperature around the
remote control unit may differ from the temperature detected at the
air conditioner's position.
) when in the manual ( ) mode,
mark will appear at the display. And the room temperature
9