Applicable Controls - Toshiba MMK-AP0057HP-E Service Manual

11

APPLICABLE CONTROLS

A wired remote controller is necessary for this function. This function cannot be operate with a wireless
remote controller.
REQUIREMENT
time, it takes approx. 5 minutes until the remote
controller becomes available after power-on.
This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
on flashes
<When power is turned on for the second (or
later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
on flashes
unit was shipped from factory.
settings.
wireless remote controller, sub remote
controller, or remote-controller less system
Therefore, install the wired remote controller
to change the settings.
1111058602_EN.indd 27
Approx. 5 minutes
Remote
goes out controller is
available
Approx. 1 minutes
Remote
goes out controller is
available
- 94 -
FILE NO. SVM-17045
Changing of settings of for
applicable controls
Basic procedure for changing settings
the former types of remote controller (RBC-
4
6
5
1
1
Procedure
Push button and "TEMP."
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure.
erase the display content, and repeat the
is pushed, the indoor unit number
Installation Manual
1
3
2
button
11/24/16 11:41 AM 11110586