Table of Contents
Advertisement
Answering system
Problem
The unit does not record new
messages.
I cannot operate the answering
system remotely.
The unit does not emit the
specified number of rings.
Liquid damage
Problem
Liquid or other form of moisture
has entered the handset/base
unit.
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
TG684xC(en)_1220_ver013.pdf
Cause/solution
R The answering system is turned off. Turn it on (page 39).
R The message memory is full. Erase unnecessary
messages (page 40).
R The recording time is set to "Greeting only". Change
the setting (page 45).
R If you subscribe to a Voice Mail service, messages are
recorded by your service provider/telephone company,
not your telephone. Change the unit's number of rings
setting or contact your service provider/telephone
company (page 44).
R The remote access code is not set. Set the remote
access code (page 43).
R You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 43).
R The answering system is turned off. Turn it on (page 44).
R If the first ring is turned off, the number of rings decreases
by 1 from the specified number of rings.
Cause/solution
R Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service centre.
55
Useful Information
2012/12/20
14:59:08
55
Advertisement
Table of Contents
