Table of Contents
Advertisement
Programming
Sub-menu 1
Change language
(Display)
Main menu:
"Cust. Support"
Operation
Displaying customer support Web address.
*1
If you program these settings using one of the units, you do not need to program the same
item using another unit.
*2
This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3
This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select "Caller ID auto". To turn this feature off, select
"Manual". (Call Display subscribers only)
To use this feature, set the date and time first (page 13).
*4
If you subscribe to a distinctive ring service, select a tone (tone 1 to 3). If you select a
melody, you cannot distinguish lines by their ringers.
*5
If you select one of the melody ringer tones, it will continue to play for several seconds even
if the caller has already hung up. You may either hear a dial tone or no one on the line when
you answer the call.
*6
The preset melodies in this product are used with permission of © 2009 Copyrights Vision
Inc.
*7
Turn this feature off if you prefer not to hear key tones while you are dialing or pressing any
keys, including confirmation tones and error tones.
*8
If you subscribe to a Call Display service and want to view the caller's information after lifting
up the handset to answer a call, turn off this feature.
*9
The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*10 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to "A" if telephone line condition is not good.
*11 This setting is available when you have the key detector (KX-TGA20). Read the installation
guide for more information on the key detector.
*12 For models with supplied key detectors, the display shows "1: Detector1".
*13 If you register 2 or more key detectors.
*14 If you have 2 or more key detectors.
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
30
TG684xC(en)_1220_ver013.pdf
Sub-menu 2
–
Important:
R Set the date and time beforehand
1
30
Settings
<English>
Français
(page 13).
Handset
MMENUN#720
2012/12/20
14:59:07
Code
#110
13
Code
#680
–
Advertisement
Table of Contents
