Miele CVA 6805 Operating And Installation Instructions page 80

Cleaning blockages from the milk pipework
To reassemble the lid:.
^ First insert the seal in the lid. Then fit
the milk intake tube into the seal.
Make sure that you do not fit the
slanted end of the milk intake tube
into the seal.
Step 2: Cleaning the air intake
tube and the angled connector
in the inside of the machine
front
Do not use a needle or similar
implement. This would damage the
components.
^ Open the service panel on the inside
of the front of the coffee machine.
80
^ First release air intake tube a from
opening c. Then pull off angled
connector b.
^ Pull both tubes out of the angled
connector.
^ Use the cleaning brush supplied to
clean air intake tube a. "Blowing
through" can also help to dislodge
blockages.
^ Clean the opening in the door for air
intake tube c.
^ Clean angled connector b under
running water. If necessary, replace it
with the spare part supplied.
^ Insert the brush in milk tube d. Move
the brush back and forth as far as
possible until all milk deposits have
been removed.