Husky T-124C Owners Manual And Assembly page 32

Industrial tricycles
Hide thumbs Also See for T-124C:
Table of Contents

Advertisement

6.
Follow patch kit's instructions for patching the leak. Inflate the tube
before putting the tube back to check for any other leaks. If no other
leaks are found, deflate the tube. Dismount the tire from the rim.
Feel around the inside of the tire to find the cause. Check the rim for
any damage or sharp objects. Wipe the rim and inside the tire clean.
7.
Work one side of the tire over the edge of the rim. The other side
should hang out. Inflate the tube slightly to form a round shape.
Start working the tube under the tire by first inserting the valve into
the valve hole.
8.
When the tube is mounted over the rim and under one side of the tire,
try pushing the other side of tire bead over the edge of the rim. Once
you reach the last 2 inches use the palm of your hand to slide the rest
of the tire over the rim. Try not using the tire lever at this time as the
lever can pinch the tube and cause a puncture. Most tires can be
mounted on the rim without the use of a tool.
9.
Check the bead of the tire and make sure you do not see any part of
the tube left out or pinched under. The bead must be seated within
the wall of the rim.
10. Inflate the tire by pumping 4 or 5 strokes. Check the tire seating and
make sure the bead is not hanging out of the edge of the rim.
11. You can now inflate the tire to the proper pressure indicated on the
sidewall. If you do not have a pressure gauge, inflate until you
cannot press the tire in more than 1/8".
12. Screw the valve cap on the valve and install the wheel back on the
bike. When installing the front wheel, make sure that the wheel is
centered on the fork as you tighten the axle nuts.
REPLACING FRONT BRAKE SHOES
A worn-out brake shoe must be replaced as soon as the depth of rubber
thread is 1/8" or less. To replace the shoes, remove the nuts and washer
using a 5mm Allen wrench. When replacing the shoes, leave about 1mm
gap between the shoes and the wheel's side-wall. Also make sure that
the shoes are centered on the side-wall. BRAKE SHOES MUST NOT
RUB AGAINST THE TIRE OR HANG BELLOW THE WHEEL'S SIDE-
WALL.
VISIT
www.huskybicycles.com
accessories for your Husky tricycle.
32
to find parts and

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T-326

Table of Contents