Husky T-124C Owners Manual And Assembly page 25

the stem bolt making sure that the front wheel is lined up with the
frame tube.
BRAKE - Install the brake lever on the right side of handlebar (left
side for 3-speed models) at a position easy to reach while holding
the handlebar grip area. Install the grips. Attach brake cable to
lever by pulling the lever to expose cable pull anchor. Place the
cable end into the anchor, run the cable through the adjusting
barrel and insert the cable housing ferrule into the lever adjusting
bolt.
Adjusting Barrel
Run the other end of the cable and housing through the reflector
bracket and attach the open end of the cable to the brake set as
shown below. The cable has to be inserted through the noodle
and the brake boot. Anchor the cable to the anchor bolt and
tighten the bolt using a 5mm Allen key while holding the brake
arms in a closed position. Trim the end of the cable to desired
length and place cable end cap on the cable end and press it with
a pair of pliers. Adjust the brake shoes for the recommended gap.
Cable
Noodle
Cable
Boot
Cable pull anchor
5mm Allen Key
25