Husky T-124C Owners Manual And Assembly page 22

22
STEP 1 - ASSEMBLE THE FRAME
1. Place the front and rear frames on a bench and position each
part so that the connecting brackets face each other.
2. Slide the frame brackets so that they overlap. Insert 4 large
square keyed frame bolts through the inside of the brackets (2 on
each side) and install washers and nylon insert nuts. See the
picture below. DO NOT TIGHTEN THE BOLTS.
3. Remove the small chain from the bag and place the chain over
the coaster brake hub and rear axle. Using the connecting link, link
plate, and snap-on clip supplied with the small chain, place the
chain over the axle and coaster brake sprockets and connect the
ends of the chain together. MAKE SURE THAT THE SANP-ON
CLIP IS SECURED ON THE CHAIN PINS. Apply tension to the
chain by pulling the front and rear frames apart. While applying
tension, tighten the frame bolts.
Make sure the rear axle sprocket is lined up with the inside
sprocket on the coaster brake hub. If the rear sprocket is not
correctly lined up, loosen the set screw and slide the sprocket on
the rear axle until it is lined up.
Set screw