Others - Pioneer HTZ-323BD Operating Instructions Manual

Others

Problem Check
Power does not Is the power cord properly
turned on. connected?
Power turns OFF without
warning
The player's power turns
Is Control set to On?
off automatically.
The player's power turns Is Control set to On?
on automatically.
Cannot be operated with Are you operating the remote
the remote control. control from a point too far
away from the player?
Are the batteries dead?
Settings I have made have y Have you disconnected the
been cleared. power cord while the player's
power was on?
y Has there been a power
failure?
USB (external storage) Is the USB device properly
device does not work with connected?
this player properly.
Is the USB device connected
via an extension cable?
Is the external storage device
connected to the USB port via
a memory card reader or USB
hub?
Does the external storage
device contain multiple
partitions?
Is the external storage device
write-protected?
Is the external storage device's
file system FAT16 or FAT32?
Display window is dark
Remedy
y Plug the power cord securely into the power outlet.
y Unplug the power cord, wait several seconds, then plug the power
cord back in.
Auto Power Off is set. The display will move to screen saver mode in 1
minutes and will automatically power OFF in about 30 minutes.
The player's power may turn off together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn off when the TV's power is turned off, set Control to Off
(page 58).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set Control to Off
(page 58).
Operate from within 7 m of the remote control sensor.
Replace the batteries (page 9).
Always press  STANDBY/ON on the player's front panel or 
STANDBY/ON on the remote control, check that POWER OFF has turned
off from the player's front panel display and wait for more than 10
seconds before disconnecting the power cord. Be particularly careful
when the power cord is connected to the AC outlet on another device
because the player turns off in conjunction with the device.
y Turn the player's power off, then turn the power back on.
y Turn the player's power off, then reconnect the external storage device
(page 34).
Do not use an extension cable. The player may not work properly with it.
External storage device may not work if connected to the USB port via a
memory card reader or USB hub.
External storage devices may not be recognized if they contain multiple
partitions.
Some external storage devices may not operate.
Turn the player's power off, then disable the write-protection.
Only external storage devices with a FAT16 or FAT32 file system can be
used.
Turn the player's power off, then turn the power back on.
Press the DIMMER on the remote and select the desired display
brightness.
Troubleshooting 71
En
9