Remote Set Point - Brainchild BTC-2500 User Manual

4 5 Remote Set Point

4 5 Remote Set Point
SPMD selecting PV1 or PV2 will enable the BTC-2500 to accept a remote set SPMD selecting PV1 or PV2 will enable the BTC-2500 to accept a remote set
point signal. If PV1 is selected for SPMD, the remote set point signal is sent to point signal. If PV1 is selected for SPMD, the remote set point signal is sent to
Input 1, and Input 2 is used for process signal input. If PV2 is selected for Input 1, and Input 2 is used for process signal input. If PV2 is selected for
SPMD, the remote set point signal is sent to Input 2, and Input 1 is used for SPMD, the remote set point signal is sent to Input 2, and Input 1 is used for
process signal. To achieve this, set the following parameters in the Setup process signal. To achieve this, set the following parameters in the Setup
menu. menu.
Case 1: Use Input 2 to accept remote set point Case 1: Use Input 2 to accept remote set point
FUNC=FULL FUNC=FULL
IN2, IN2U, DP2, IN2L, IN2H, are set according to remote signal. IN2, IN2U, DP2, IN2L, IN2H, are set according to remote signal.
PVMD=PV1 PVMD=PV1
IN1, IN1U, DP1, are set according to the process signal IN1, IN1U, DP1, are set according to the process signal
IN1L, IN1H if available, are set according to the process signal IN1L, IN1H if available, are set according to the process signal
SPMD= PV2 SPMD= PV2
Case 2: Use Input 1 to accept remote set point Case 2: Use Input 1 to accept remote set point
FUNC=FULL FUNC=FULL
IN1, IN1U, DP1, IN1L, IN1H, are set according to remote signal. IN1, IN1U, DP1, IN1L, IN1H, are set according to remote signal.
PVMD=PV2 PVMD=PV2
IN2, IN2U, DP2, are set according to the process signal IN2, IN2U, DP2, are set according to the process signal
IN2L, IN2H if available, are set according to the process signal IN2L, IN2H if available, are set according to the process signal
SPMD= PV1 SPMD= PV1
Note: If PV1 are chosen for both SPMD and PVMD, an Note: If PV1 are chosen for both SPMD and PVMD, an
appear. If PV2 are chosen for both SPMD and PVMD, an appear. If PV2 are chosen for both SPMD and PVMD, an
will appear. You should not use these cases, otherwise, the BTC-2500 will not will appear. You should not use these cases, otherwise, the BTC-2500 will not
control properly. control properly.
Error Code will Error Code will
Error Code Error Code
UM25001C
Setup
FUNC=FULL FUNC=FULL
SPMD=PV2, PVMD=PV1 SPMD=PV2, PVMD=PV1
or SPMD=PV1, PVMD=PV2 or SPMD=PV1, PVMD=PV2
Error Message Error Message
73