Table of Contents
Advertisement
Chapter 2 Installation
Chapter 2 Installation
Dangerous voltages capable of causing death are sometimes present
Dangerous voltages capable of causing death are sometimes present
in this instrument. Before installation or beginning any troubleshooting
in this instrument. Before installation or beginning any troubleshooting
procedures the power to all equipment must be switched off and isolated. Units
procedures the power to all equipment must be switched off and isolated. Units
suspected of being faulty must be disconnected and removed to a properly
suspected of being faulty must be disconnected and removed to a properly
equipped workshop for testing and repair. Component replacement and internal
equipped workshop for testing and repair. Component replacement and internal
adjustments must be made by a qualified maintenance person only.
adjustments must be made by a qualified maintenance person only.
To minimize the possibility of fire or shock hazards, do not expose this
To minimize the possibility of fire or shock hazards, do not expose this
instrument to rain or excessive moisture.
instrument to rain or excessive moisture.
Do not use this instrument in areas under hazardous conditions such as
Do not use this instrument in areas under hazardous conditions such as
excessive shock, vibration, dirt, moisture, corrosive gases or oil. The ambient
excessive shock, vibration, dirt, moisture, corrosive gases or oil. The ambient
temperature of the areas should not exceed the maximum rating specified in Chapter 8.
temperature of the areas should not exceed the maximum rating specified in Chapter 8.
2 1 Unpacking
2 1 Unpacking
Upon receipt of the shipment remove the unit from the carton and inspect the
Upon receipt of the shipment remove the unit from the carton and inspect the
unit for shipping damage.
unit for shipping damage.
If any damage due to transit , report and claim with the carrier.
If any damage due to transit , report and claim with the carrier.
Write down the model number, serial number, and date code for future reference
Write down the model number, serial number, and date code for future reference
when corresponding with our service center. The serial number (S/N) and date
when corresponding with our service center. The serial number (S/N) and date
code (D/C) are labeled on the box and the housing of control.
code (D/C) are labeled on the box and the housing of control.
2 2 Mounting
2 2 Mounting
Make panel cutout to dimension shown in Figure 2.1.
Make panel cutout to dimension shown in Figure 2.1.
Take both mounting clamps away and insert the controller into panel cutout.
Take both mounting clamps away and insert the controller into panel cutout.
Install the mounting clamps back. Gently tighten the screws in the clamp till the
Install the mounting clamps back. Gently tighten the screws in the clamp till the
controller front panels is fitted snugly in the cutout.
controller front panels is fitted snugly in the cutout.
45 +0.5
_
0
+0.3
22.2
_
0
12.5mm
MOUNTING
CLAMP
SCREW
Panel
8.0mm
10.0mm
UM25001C
Figure 2.1
Figure 2.1
Mounting Dimensions
Mounting Dimensions
21
Hide quick links:
Advertisement
Table of Contents
