Programming Port - Brainchild BTC-2500 User Manual

2 18 Programming Port

2 18 Programming Port
See Figure 1.3 in Section 1-3 to find the programming port location. See Figure 1.3 in Section 1-3 to find the programming port location.
Programmer Programmer
connector and connector and
ATE connector ATE connector
inserted here inserted here
Access hole Access hole
on the on the
bottom view bottom view
NOTE
The programming port is used for off-line automatic setup and testing procedures only. The programming port is used for off-line automatic setup and testing procedures only.
Don't attempt to make any connection to these pins when the unit is used for a normal Don't attempt to make any connection to these pins when the unit is used for a normal
control purpose. control purpose.
Programmer Programmer
P11A P11A
I N P T 1
Switch Unit
DMM
Calibrator
UM25001C
Figure 2.23 Programming Figure 2.23 Programming
Port Wiring Port Wiring
SW6400
HP 34401A HP 34401A
Fluke 5520A Fluke 5520A
39