Table of Contents
Advertisement
Traditional Whirlpool
After the pedicure spa is installed and the plumbing and electrical connections are made, clean and
disinfect the basin before initial use. Rinse the basin by using the attached water sprayer. Wipe the
basin dry with a clean towel.
To Operate the Pedicure Spa, Follow These Easy Steps:
Adding Water to the Pedicure Spa Basin:
1. Close the drain by turning the chrome drain handle counter-clockwise until it stops.
2. Add water to the basin by lifting upward on the water faucet fill handle. Turn the handle in a
counter-clockwise direction for cold water or clockwise for warm water as indicated by the red
(hot) and blue (cold) markings around the handle (CAUTION: hot water can burn skin). Continue
to add water until the fill line is reached. The fill line is indicated by the wavy (~~~~) line in the
basin.
3. Turn the off water by pushing the handle downward and center.
Operating the Water Jets:
Each pedicure spa is equipped with two fully adjustable jets that create a soothing foot massage. To
operate, turn the whirlpool jets on by turning the On/Off Switch in a clockwise direction. To increase
jet strength, open each jet by simply rotating the adjustment cover in a counter-clockwise direction.
To decrease water pressure, close each jet by rotating the adjustment cover in a clockwise direction
(NOTE: The Jet heads should not be positioned directly at the suction cover. Doing so will
create a noisy "gurgling" sound as air is being forced directly into water pipes). Turn off the
whirlpool jets by turning the On/Off switch counter-clockwise to its original starting position.
Removing Water from the Pedicure Spa Basin:
First, make certain the whirlpool jets are off by turning the On/Off Switch counter-clockwise to the
"Off" position.
If the pedicure spa is hooked up directly to a floor drain, simply open the drain by turning the drain
handle in a clockwise direction until it stops. You should see the water level lowering as water exits
the basin.
If the pedicure spa is equipped with the optional Power Drain Pump (PDP) feature, open the drain by
turning the drain handle in a clockwise direction until it stops, and then press the button marked
"Drain" on the front panel. The water level will lower as water is pumped out of the basin. Turn the
pump off by pressing the "Drain" button on the front panel once the basin is fully drained. (NOTE:
The Power Drain Pump will automatically shut off after 2-1/2 minutes. We recommend turning
off the pump manually if all water has drained before automatic shut-off.)
Warning:
It is extremely important to follow the cleaning instructions located on the following page.
Failure to clean the pedicure spa adequately can result in serious health issues for your
clients as well as the nail technician. Failing to clean your pedicure spa may also cause the
pedicure spa to not work properly. Please consult your local and state codes concerning
pedicure chair cleaning for further requirements.
Document ID:06080001
(With Jets)
Rev: B
Technical Support: 800-626-6912
- Operating Instructions
Page 18 of 24
Advertisement
Table of Contents
