Attaching The Cushions - European Touch Solace FORTE' Owner's Manual

All pedicure spa cushions attach to the pedicure spa with Velcro. The Forte' and Altera Pedicure spas
have cables for the cushions that need to be routed properly. Follow these instructions for attaching
the cushions properly to your pedicure spa:
Use the following instructions for all cushion models:
Step 1: Your pedicure spa will
come with the Velcro already in
place for the seat bottom and
the seat back.
Step 2: Attach the seat bottom to
the chair bottom.
that the cushion is centered on
the chair bottom.
should be able to close without
cushion interference.
Step 3: Route the seat back
cushion cables underneath the
chair back and out the back.
Center the seatback cushion on
the chair back.
Document ID:06080001

Attaching the Cushions

Step 4: Remove the protective film
from the Velcro on the bottom
of the arm pads.
place the arm pads on the chair
arms and slide the remotes
under the remote holders on
the arm pads.
Step 5: FORTE' ONLY – The
Make sure remote
supply cord are taped together
The arms behind the chair. Remove the
tape and connect the cords
from the cushion to these
connectors.
Step 6: FORTE' ONLY – Route
the seat back cables through
the hole in the pedicure spa
base.
Rev: B
Carefully
control and power
Technical Support: 800-626-6912
Step 7: ALTERA VIBRATION
ONLY – The Altera cushion
remote control comes attached
to the junction box.
Step 8:
ALTERA VIBRATION
ONLY – The Altera junction
box should be mounted on the
back of the seat back.
the 2 cushion cords into the
red and white receptacles
(they can go into
receptacle). The power supply
cord plugs into the receptacle
next to the remote cord. Plug
the power supply into the
power strip.
Step 9: The remotes can be
slipped into the armrests as
shown.
Plug
either
Page 14 of 24