Table of Contents
Advertisement
Hot and cold water supply lines required (hot and cold shut offs may be installed under pedicure spa
Drain installation:
Overall dimensions without accessories, seat upright: 54"L (138cm) x 31"W (82cm) x 56"H
Without accessories, seat collapsed: (shipping position): 54"L (138cm) x 32"W (82cm) x 36"H
Shipping dimensions:
Empty weight:
Shipping weight:
Capacity of basin:
Whirlpool pump motor:
Forte' seat and back motors: 30V DC Linear Actuators. Forte' requires 18" (46 cm) of space between
Altera seat and back movement: 2 infinitely adjustable lockable gas cylinders for reclining/sliding.
Massage motor:
Power source:
Caution: Pedicure spa must be installed by a licensed electrician and a licensed
plumber, conforming to all local and national electrical codes.
Construction: Linear Low Density Polyethylene (LLDPE), self-contained, pre-plumbed
™
Crystal Clean
Pipe-Free
Hydro-Therapeutic (Jet System: Traditional Whirlpool pedicure spas): PVC, two (2) fully-
Electrical switches:
UL listed/CE certified:
Limited warranty:
Due to our policy of continuous improvements, all specifications are subject to change without notice.
Document ID:06080001
Specifications
base) See pages seven through ten.
references noted on pages seven through ten, can be installed with
optional power drain pump or as gravity drain.
(143cm)*
(92cm)*
55"L (140cm) x 33"W (87cm) x 41"H (108cm)*
150 Ibs (68kg)*
205 lbs (92kg)*
5 U.S. Gallons = Traditional Whirlpool
6.5 U.S. Gallons = Crystal Clean
1/6 HP, 110V, 60HZ (alternate voltages available) (3/4 HP for Traditional
Whirlpool -
)
with Jets
pedicure spa and wall with standard actuator, and 24" (61 cm) with fully-
reclining actuator.*
The Altera requires 12" (31cm) of space between pedicure spa and wall
in order for seat to recline to its fullest extent.*
12V AC, Adapter included (alternate voltages available)
110V AC/ 5 Amp, 60 Hz (GFCI Protected)
®
water massage system (pipe-free pedicure spas): 'underfoot' footplate
water massage grooves, no closed loop circulating pipes, 100% fully
drained, and cleanable
directional jets, built-in air control
On/Off switch for whirlpool pump. Hand-held low voltage remote controls
for massage motors, heat and seat/back position hot and cold water
supply lines required
Complies with ASME/ANSI Whirlpool Bathtub Specs ASME/ANSI
A112.19 7M-1995 and A112.19.8M-1995. Backflow Protection Devices
for Faucets with Side Spray: Check valves comply with ANSI/ASME
A112.18.3M, A112.18.1M, and CSA B125.
One (1) year from date of purchase.
Rev: B
(with Jets)
™
®
Pipe-Free
*Note: All dimensions and weights are approximate
Technical Support: 800-626-6912
*
*
Page 11 of 24
Advertisement
Table of Contents
