Advertisement
Assembly Instructions
1. Insert the burner into the cooker stand and
through the cut-out opening in the side of the
stand.
2. Insert the threaded pin on the bottom of the
burner into the center hole in the burner bracket.
Make sure the alignment pin is seated in the
notch on the edge of the burner bracket.
3. Place the heat shield beneath the burner bracket,
aligned with the burner pins, and secure with the
#10-24 hex nut (keps).
4. Place the damper over the end of the burner.
Insert the brass hose fitting into the small end of
the spring, then thread brass fitting into the burner
and tighten. Be sure not to strip threads on brass
fitting. DO NOT OVERTIGHTEN. Proper
connection is critical for correct operation of unit.
Threaded
Pin
Nut
Heat Shield
Damper
Spring
Hose
Burner
Alignment
Pin
15
Advertisement
