Barco CRPN-52B User Manual page 25

5.6 Connection and cables
5.6.1 Setting up a video source
5.6.2 Setting up a computer source
5.6.3 Connecting command and control interfaces
25
Before setting up, switch off all equipment and disconnect the power cord. In order to
prevent damage to the projector caused by overvoltages (e.g. lightning), connect to a
line (mains) circuit which has overvoltage protection when installing.
For best quality video, connect a digital video source using the HDMI 1.3a interface (O) Con-
necting a video source in Figure 5-4. The HDMI input is HDCP copy protection compliant.
Depending on cable quality, the projector is supporting the use of cables with lengths up 20
meters (65 feet).
Figure 5-4. Connecting a video source
The projector may be connected to up to six computer sources simultaneously, using the
HDMI (O), DVI-D (J) or VGA (K) interfaces, shown in Figure 5-4/Figure 5-5. The digital inter-
faces (DVI/HDMI) will yield a projected image with very low noise.
Both DVI and HDMI are HDCP compliant with sources up to 1920x1200@60Hz (single link
source up to 165 Mhz). Additional functionality may be acchieved using additional X-PORT
connectors like 3G-SDI, DisplayPort 1.1a (se separate sections).
Figure 5-5. Connecting a computer source
HDCP is not supported on higher resolution sources like 2560x1600@60Hz (WQXGA).
Connect the power cord after the other cables have been inserted properly.
The projector is supporting RS-232 and LAN command and control interfaces. Use the ASCII
based protocol to communicate with the projector. A detailed description of the ASCII proto-
col is available for download at www.projectiondesign.com.Connect the power cord after the
command and control cables are inserted properly.
Figure 5-6. Connecting command interfaces www.projectiondesign.com