Q-See QT454 User Manual page 24

STEP 4. Select the Setup icon in the
Main Menu (Red Box in
Picture
7-7)
STEP 5. Select the Network icon (Red
box in Picture 7-8)
STEP 6. Enter the gateway and subnet
mask numbers into the appropriate
fields (Green arrows in Picture
7-9)
STEP 7. For the DVR's IP address, you
will need to enter the first three sets of
numbers from the IP4v address into
the IP Address field (Blue arrow in
Picture 7-9).
46
PICTURE 7-7
PICTURE 7-8
PICTURE 7-9
STEP 8. To finish the IP address, you will need to enter a fourth set of numbers that
is different than any other device attached to the same router. If the fourth set of
numbers in your IP4v address is a single or double-digit number, then you can enter
any three-digit number up to 254. If, on the other hand, the IP4v address ended with a
number in the 100s, then enter a number between 200 and 254.
STEP 9. Click the Test button (Red box in
conflict.
A. If you get the OK message in the lower left corner of your screen, you may click on
the Apply button before closing the window.
B. If you get a failure message then try a different three-digit number for the IP
address.
IMPORTANT! Do not use 255 or higher to complete your IP address as these
addresses are reserved for other devices and components.
Picture 7-9) to verify that your settings avoid
47