Table of Contents
Advertisement
1-7 Configuring Application Format Settings
The O menu includes format settings for configuring the number of calculation result display digits and
the angle unit, as well as application-specific commands. The following describes each of the settings and
commands that are available on the O menu.
To do this:
Specify folder for variables, and to configure number format, angle, and other basic
settings for all built-in applications
Configure Graph window and graph drawing settings for Graph & Table, Conics, and
other graphing applications
Configure number format, angle, and other settings for Geometry application
Configure Fourier transform and FFT settings
Configure Financial application settings
Return all the above menu settings to their initial default values (except for the current
folder setting specified on Basic Format dialog box)
u To configure application format settings
1. Open any application (except the System application).
2. Tap O. Next, tap the menu command you want: Basic Format, Graph Format, Geometry Format, Advanced
Format, or Financial Format.
3. Use the dialog box to configure the settings you want.
• For details about the settings you can configure on each of the dialog boxes, see "Application Format
Settings" below.
4. To close a dialog box and apply its settings, tap [Set]. To close a dialog box without applying its settings, tap
[Cancel] or the C button in the upper right corner of the dialog box.
Application Format Settings
This section provides details about all of the settings you can configure using the application format settings.
Settings marked with an asterisk (*) in the following explanations are ClassPad initial default settings.
k Basic Format Dialog Box
Use the Basic Format dialog box to configure basic settings for calculations, cells, and other parameters.
To specify the current folder
Tap 1 and then tap the name of the folder (main*) you want.
1
To specify the numeric value display format
Tap 2 and then tap one of the settings described below.
2
Normal 1*: Automatically uses exponential display format when calculation
3
x
−2
result
is: 10
Normal 2: Automatically uses exponential display format when calculation
x
result
is: 10
−9
Fix 0 – Fix 9: Fixed number of decimal places
Sci 0 – Sci 9: Fixed number of significant digits
To specify the angle unit
Tap 3, and then tap "Radian*", "Degree", or "Grad".
| t 10
x
x
10
> |
| or |
.
| t 10
x
x
> |
| or |
10
.
Select this O
menu command:
Basic Format
Graph Format
Geometry Format
Advanced Format
Financial Format
Default Setup
Chapter 1: Basics 36
Advertisement
Table of Contents
