Table of Contents
Advertisement
164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
1. Mist — Press the end of the Multifunction Lever
inward to the first detent and release to clear the wind-
shield. Pressing the Multifunction Lever inward to the
second detent will cause the washers to spray for a
maximum of 20 seconds or until the lever is released and
the wipers will cycle three times.
NOTE: If the Multifunction Lever is depressed while in
the delay range, the wipers will operate for several
seconds after the lever is released, and then resume the
intermittent interval previously selected.
If the Multifunction Lever is depressed while in the OFF
position, the wipers will operate for approximately two
wipe cycles, then turn OFF.
2. Intermittent, Low and High Speed Wipers — Use the
intermittent wipers when weather conditions make a
single wiping cycle, with a variable pause between
cycles, desirable. Rotate the end of the Multifunction
Lever to the first detent position, then turn the end of the
lever to select the desired delay interval. The delay can be
regulated from a maximum of about 20 seconds between
cycles, to a cycle every 2 seconds. The time delay will be
doubled if the vehicle speed is less than 10 mph (16
km/h).
Low Speed is achieved by rotating the Multifunction
Lever past the intermittent settings, to the first detent.
High Speed is achieved by rotating the Multifunction
Lever past the intermittent settings, to the second detent.
3. Rear Window Functions — Rotating the Rotary Ring
to the first detent activates the rear intermittent wipers.
To activate the washers, rotate the Rotary Ring fully
forward and the washers will spray until the ring is
released, and then resume the intermittent interval.
NOTE: Rear Window Wipers are supplied with the
intermittent feature only.
Advertisement
Table of Contents
