Table of Contents
Advertisement
Getting started
Location
You need to place your BT Paragon 550 close enough to a mains
power and telephone socket so that the cables will reach.
Setting up
1. Attach the desk mounting plinth. The telephone line cord is
pre-installed but make sure you route the cable through the
grooves in the plinth. Do not route the line cord under the
plinth as you could damage it.
2. Connect the longer straight end of the curly handset cord into
the base. Connect the other end of the cord to the handset.
3. Plug the mains power adaptor into the power socket on the
underside of the base. Plug the other end into the mains
socket and switch the power on. The display lights up.
If you experience any problems, please call the Helpline on 0800 218 2182* or email bt.helpdesk@vtecheurope.com
Cord channel for line cord
Cord channel for power supply cord
WARNING
Do not place your BT Paragon 550 in
the bathroom or other humid areas.
IMPORTANT
The BT Paragon 550 will still be able
to take and receive calls during
power failure as long as the
telephone line cord is still plugged in.
Full functionality will of course
be limited.
Using your BT Paragon 550 on a
Broadband line?
If this product is to be used on a
broadband line then you must ensure
that it is connected via an ADSL
microfilter. Using this product on a
Broadband line without an ADSL
microfilter may cause problems with
this product and your Broadband
service.
Additional BT ADSL microfilters can be
purchased from www.shop.bt.com
Hearing aid wearers may benefit
from switching their hearing aid to the
middle T position and holding the
earpiece up to the aid not their ear.
If you experience poor speech quality
or interference, make sure the product
is not located too close to other
electrical appliances.
7
Advertisement
Table of Contents
