Install Qfe Update Software; Create An Emergency Repair Disk - Intergraph StudioZ RenderRAX System Setup

8. Select REG_DWORD for the Data Type, and then select OK.
9. Type 1 into the Data box.
10. Set the Radix value to Hex, and then select OK.
11. Exit from the Registry Editor and restart the system.

Install QFE Update Software

If your system was shipped with Quick-Fix Engineering (QFE) update software, you created a
QFE diskette using Version Manager. Insert the QFE diskette into the floppy drive. Refer to
the
README

Create an Emergency Repair Disk

The files on the Emergency Repair Disk can restore a damaged registry to its original contents
(that is, at the time Windows NT was installed), along with the standard Windows NT drivers.
CAUTION Once you have created all of your user accounts and have finished configuring the system,
Intergraph recommends that you create an Emergency Repair Disk using the RDISK.EXE
utility. Use this utility to update the Emergency Repair Disk any time you change your
system's configuration. You should also make and keep a backup copy of the Emergency
Repair Disk.
Refer to Windows NT Help for information on creating an Emergency Repair Disk, and to
Microsoft's Start Here for information on using it.
. file on the QFE diskette for instructions to update the system.
TXT
43