Troubleshooting; Checking The System; System Boot Errors; Series Of Beeps And Error Message Displays - Intergraph StudioZ RenderRAX System Setup

4 Troubleshooting

Checking the System

If your system exhibits errors, or hardware is not functioning properly, check the following
items:
u
All hardware is properly and securely installed, and powered on.
u
The cables are properly attached from the base unit to the various options and to the
peripherals installed in the rack or in remote locations.
u
The cables that run along the sides or top of the rack are installed in clips or ties to secure
them in place.
u
The power cord from the AC distribution box or UPS is attached to the correct wall
outlet.
u
The equipment attached to the AC distribution box or UPS does not exceed the stated
power limitations.

System Boot Errors

Series of beeps and error message displays

Number of Beeps - Message
1 - Refresh Failure
2 - Parity Error
3 - Base 64 KB Memory Error
Explanation and Solution
Bad memory refresh circuitry on the system
board. SIMMs need to be reseated. If error
continues, replace SIMMs.
Parity error in the first 64 KB block of
memory. SIMMs need to be reseated. If
error continues, replace SIMMs.
Memory failure in the first 64 KB. Ensure
the installed memory is in a valid
configuration. If so, SIMMs need to be
reseated. If error continues, replace SIMMs.
Check the System Control Panel for faulty
SIMMs. If there is no indication of faulty
SIMMs, call the Customer Response Center.
33