Table of Contents
Advertisement
The Heidi Device Driver is installed during installation of the Intergraph Display Driver for
RealiZm graphics. After you install 3D Studio MAX on your system, copy the Heidi Device
Driver file
3
\
DSMAX
DRIVER
NOTE
Use the version of the Heidi driver that matches the version of the display driver.
Refer to the
on the driver and any associated files.
Configuring Networking
If the system has an installed network adapter, you must configure the operating system to use
it. Before you configure networking, make sure that the system has an installed network
adapter, and that the system is connected to the network.
To configure networking, open Network in the Control Panel. Follow the instructions in the
dialogs to set up the system to use a network. Be sure to set up the appropriate network
protocols, such as TCP/IP and NetBEUI, for the network to which your system is connected.
Refer to the documentation for the installed network adapter for detailed configuration
instructions. Refer to the operating system documentation and Help for information on setting
up the system to use a network.
Configuring External SCSI Peripherals
Desktop systems are equipped with an Ultra SCSI controller for all SCSI devices. If you use a
non-Ultra SCSI device, data transfer rates are limited to the device's speed.
Deskside systems are equipped with a separate SCSI-2 controller for external SCSI devices.
You should use only SCSI-2 devices with the external SCSI port. If you use an Ultra SCSI
device, data transfer rates are limited to the controller's SCSI-2 speed. If you use a SCSI-1
device, data transfer rates are limited to the device's speed.
CAUTION
Using a non-compliant SCSI-1 device with your system may cause your system to stop
working, or lead to other unpredictable results.
You can use up to five external single-ended SCSI devices with a desktop system, and up to
seven external single-ended SCSI devices with a deskside system. The total length of the
external SCSI cables depends on the number of devices connected to the SCSI adapter. The
total length must not exceed the following:
.
from the Windows NT Workstation
GLZIHDD
HDI
directory.
.
file delivered with the Heidi Device Driver for detailed instructions
README
TXT
32 directory to the
SYSTEM
13
Advertisement
Table of Contents
Need help?
Do you have a question about the StudioZ RenderRAX and is the answer not in the manual?
Questions and answers