Network Profiles - TANDBERG 770 MXP User Manual

WLAN Mode
AdHoc: Used when not communicating with an access point.
Managed: Used when communication is made through an access point.
Make sure the corresponding settings are programmed into the access point. Press "Restart"
from Control Panel in order to activate the settings.
Required cards
• Compaq WL110 11 Mbps Wireless LAN
• Lucent Orinoco 11 Mbit/s SILVER
• Lucent Orinoco 11 Mbit/s GOLD
• Cisco Aironet 350 series (AIR-PCM 350 series)
• Enterasys Networks RoamAbout 802.11 DS High Rate
• Melco Buffalo WLI-PCM-L11G
Recommended access point
• Compaq WL410 base station
Note! The PC card/PCMCIA-card used must compy with the relevant regulations for such
cards in the country where it is used. The unit must be supplied by power suppoy (AC-DC
adapter) powerbox SPN-270-12, which complies with the requirements for limited power
source according to IEC/EN 60950.
Encryption
Select if you want to encrypt your Wireless LAN connection. Increased encryption level will
decrease performance.
Use Select which of the keys shown below you want to use.
Key:
Key The 64-bit keys can consist of a leading star (*) and 5 characters.
1-4 The 128-bit key can consist of a leading star (*) and 13 characters.
Start with a * and then the text. Example: 128 bit key: *secretkeyhome.
Encryption using Hex numbers The 64-bit keys can consist of 10 hexadecimal digits.
Example:
"de01ad4dbe". The 128-bit key can consist of 26 hex numbers.

4.8.3 Network Profiles

This menu consists of 6 network profiles; a prefix can be added for each profile. If you add a
prefix to a profile, this prefix will automatically be added in front of the number being dialed.
Example:
0 is added as a Call Prefix to the 2nd profile, ISDN. If you enter 12345678 in the dial menu
and select ISDN, the number dialed will be 012345678.
4 Administrator Settings
99