Quick Connector Assembly - Jenn-Air 730-0163 User Manual

SIDE BURNER HOSE QUICK-CONNECT ASSEMBLY
Estimated Assembly Time: Approximately 5-7 minutes
No tools required for assembly.
1. Insert the side burner hose with male end of the quick-connect fitting through the side panel of
the cart (top drawing).
2. Push the sleeve of the female socket back and insert male end of the connector. Release the
sleeve.
3. Push the male end in until the female sleeve snaps forward to lock the fitting.
4. To disconnect the fitting, push the female sleeve back and pull the male end out (bottom
drawing).
WARNING
1. Attach the coupling half (socket) to the gas
supply line in accordance with NFPA54/ANSI
Z223.1FUEL gas code.
2. Prior to inserting the plug, test the connection
for leaks following the leak test instructions on
page 10. After the leak test is completed, rinse
the connection with clean water to remove any
corrosive residue.
3. Do not use an open flame to test for leaks.
7