Table of Contents
Advertisement
■
Make sure the lens is not fogged by condensation. If you've just moved the projector from
a cold environment, wait a couple of minutes before using it.
■
Adjust the
■
If you're projecting from a computer, you may need to adjust the
settings (see page 39).
The colors on the screen don't look right.
■
Make sure the
page 44).
■
Press the
page 27).
■
Check the brightness and contrast settings (see page 33).
■
Fine-tune the colors with the settings listed on page 36.
■
If the picture looks dark, check the
Brightness
timer to see how long the lamp has been in use (see page 55). Replace the lamp if it's close
to the end of its service life (see page 52).
Solving Remote Control Problems
The projector doesn't respond to remote control commands.
■
Make sure you're within about 30 feet of the projector, and the remote control is aimed at
the projector's front or back sensor within the ranges shown below.
Approx.60
■
You may need to replace the remote control batteries (see page 20). Press the
illumination button and check if the buttons glow. If they don't, replace the batteries.
62
Problem Solving
setting (see page 35) or turn on
Sharpness
is set correctly for your connected video equipment (see
Input Signal
button on the remote control to select a different color mode (see
Color Mode
and
. You may also need to replace the lamp. Check the lamp usage
Contrast
Approx.60
Super-resolution
setting (see page 33), as well as the
Lens Iris
Approx.60
(see page 38).
and
Tracking
Sync
Approx.60
Advertisement
Table of Contents
