Table of Contents
Advertisement
■
Select
■
Select
You should reset the lamp timer only when you install a new projector lamp. See
page 55 for more information.
Customizing Projector Features
Use the settings in this section to adjust the image size and position, suppress on-screen text,
and select basic setup options.
Image Sizing
Before adjusting any of these settings, make sure you have already selected an appropriate
aspect ratio for the type of picture you're viewing (see page 26).
■ Overscan
Signal > Advanced > Overscan
For component video formats, this setting lets you see the edges of the image that are not
normally visible in the picture. If you see interference when you set
adjusting the
■ Position
Signal > Position
Note: This setting cannot be used with a signal input through the HDMI 1 or HMDI 2 port.
Use the arrow buttons to fine-tune the position of the image on the screen.
■
Aspect
Signal > Aspect
This setting lets you change the aspect ratio of your image, and works the same as
pressing the
■ Zoom Size
Signal > Zoom Size
Lets you adjust the proportions of the image when the aspect ratio has been set to
Make sure
42
Making Detailed Adjustments
Reset Lens Position
to clear the lamp usage timer and reset it to zero.
Reset Lamp Hours
as described below.
Position
button on the remote control. See page 26 for more information.
Aspect
is set to
Overscan
Off
to clear all lens position memory settings.
before using this function.
to
, try
Overscan
Off
.
Zoom
Advertisement
Table of Contents
