Epson PowerLite Home Cinema 21000 User Manual page 44

■ Direct Power On
Settings > Operation > Direct Power On
Sets projection to start when the main power switch is turned on, without pressing the
P power button on the remote control or the projector.
Note: When Direct Power On is enabled, restoration of power after a power outage can cause
the projector to turn on.
■ Video Signal
Settings > Input Signal > Video Signal
Leave this setting on
NTSC or PAL (for standard TV formats).
■ Component
Settings > Input Signal > Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
or select
■ HDMI1 EQ Setting
HDMI2 EQ Setting
Settings > Input Signal > HDMI1 EQ Setting or HDMI2 EQ Setting
If you're using a long HDMI cable, you may have to select a higher setting to increase the
projector's sensitivity to the incoming signal. You can select a separate setting for each of
the projector's HDMI ports.
■ Trigger Out
Settings > Operation > Trigger Out
Select
Power
projection screen when the projector is running. Or select
a motorized anamorphic lens (commercially available) when the
Horiz. Squeeze
Note: If you change this setting, the new setting will take effect the next time you turn the
projector on.
■ Illumination
Settings > Operation > Illumination
Turn off this setting to deactivate the lights on the projector's Ppower button and power
light. Use this setting if you find the lights distracting in a darkened room.
44
Making Detailed Adjustments
so the projector can automatically interpret the format, such as
Auto
Auto
or to manually select your video equipment's signal.
YCbCr YPbPr
to have the
Trigger out
aspect ratio is selected.
to let the projector automatically interpret the signal;
port output a 12-volt signal to lower your
to engage
Anamorphic Wide
Anamorphic Wide
or