Solving Picture Problems - Epson PowerLite Home Cinema 21000 User Manual

Table of Contents

Advertisement

Lights indicating a problem
Light state
The temperature
light flashes red

Solving Picture Problems

You cannot turn on the projector.
Make sure the power cord is connected and the main power switch in back of the
projector is turned on. Then press the Ppower button on the projector or the
on the remote control.
If you've set the
Child Lock
on the projector, or use the remote control (see page 29).
No picture appears on the screen or you see the
Press one of the
Source
on the projector, to select the correct input source. Allow a few seconds for the projector
to sync up after pressing the button.
Press the
button on the remote control to make sure the picture hasn't been turned
Blank
off temporarily.
Check that the Ppower light is on and not flashing, and the lens cover is off.
The projector may be in standby (or sleep) mode. If necessary, press the Ppower button
on the projector or the
Make sure your video equipment is turned on.
Make sure your cable(s) are connected correctly (see page 18).
Only part of the picture is displayed, or the picture is distorted.
Press the
Aspect
If the Aspect is set to
options to see the top or bottom section of the screen so that subtitles are visible (see
Pos.
page 43).
Check the
Overscan
Cause and solution
There is a fan or sensor problem. Turn off the power switch on
the back of the projector, and unplug it from the electrical outlet.
Then contact Epson for assistance (see page 63).
, you have to press the Ppower button for 3 seconds to turn
buttons on the remote control, or press the
button on the remote control.
On
button to select a different aspect ratio (see page 26).
, you may need to use the
Zoom
to make sure it's adjusted correctly (see page 42).
message displayed.
No Signal
and
Zoom Size
button
On
source button
Zoom Caption
Problem Solving
59

Advertisement

Table of Contents
loading

Table of Contents