Table of Contents
Advertisement
fig.5
DO NOT install at an angle.
8
5. OPERATION
DO NOT use an extension cable.
8
5.1.
PLUG the unit into a plug socket, make sure the power
supply is the same as rated.
5.2.
PRESS the power button on the right side of heater.
5.3.
TURN ON the heater by remote control, or off the heater.
5.4.
RED POWER LEVEL BUTTON, setting the power level.
LED light on front of heater indicates power level. Red -
heater in standby, Green - 50%, Blue - 100%.
5.5.
PUSH BUTTON: on the right of heater, is for manual
operation without the remote control.
5.6.
REMOTE CONTROL
Button
Function (Heater On)
O
Turns heater on or off
I
Power setting
II
Power setting
NOTE:
It may be possible to control several heaters with one remote.
5.7.
INSERTING BATTERIES (NOT INCLUDED)
5.7.1.
Insert 2 AAA/ Alkaline type batteries into your remote control.
5.7.2.
Turn to the backside of your remote control and pull out battery cover. Insert the batteries
in accordance with the instructions and polarity the batteries.
5.7.3.
Push the battery cover into place after changing the batteries.
6. MAINTENANCE
6.1.
Regular and careful cleaning helps your infrared heater operate efficiently for many trouble free for years. To clean your heater follow
steps below. Unplug the heater from the mains for your safety before cleaning your appliance.
6.1.1.
Make sure the heater is cool before continuing.
6.1.2.
To keep the heater clean, the outer shell maybe cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After
cleaning, dry the unit with a soft cloth.
WARNING! DO NOT let liquids enter the heater.
‰
DO NOT use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean the heater. This may cause damage or
8
deterioration to the surface of the heater.
DO NOT immerse the heater in water.
8
6.1.3.
Wait until the heater is completely dry before use.
6.2.
STORAGE
6.2.1.
Store the heater in a cool, dry location when not in use to prevent dust and dirt build up. Use packaging carton to store.
7. TROUBLESHOOTING
7.1.
If heater will not turn on. Check the cable is plugged into an electrical outlet, if not, plug in.
7.2.
Check if electricity to the building is working.
7.3.
Bulb is lit, but no heat: Bulb is damaged. Arrange for replacement bulb with your Sealey stockist.
© Jack Sealey Limited
Remote Control Function
Function (Heater Off)
Red LED illuminates
Turns heater on to Level 1 (50%*power) Green LED illuminates
Turns heater on to Level 2 (100%*power) Blue LED illuminates
Original Language Version
fig.6
IWMH2000R.V2 Issue 3 (3,4) 11/06/2021
fig.7
fig.8
Advertisement
Table of Contents
Need help?
Do you have a question about the IWMH2000R.V2 and is the answer not in the manual?
Questions and answers